| Accession number;99A0600817 |
| Title;New Pulp Bale Feeding System and Automatic Waste Paper Bale Dewiring System by FMW. |
| Author;PESDICEK A(Foerderanlagen Und Machinenbau Ag.) ATSUURA TAKAYUKI(Itochusanki) |
Journal Title;Japan TAPPI Journal
|
Journal Code:G0115A
|
ISSN:0022-815X
|
|
VOL.53;NO.7;PAGE.887-893(1999)
|
| Figure&Table&Reference;FIG.5 |
| Pub. Country;Japan |
| Language;Japanese |
| Abstract;I. New Pulp Bale Feeding System. A mordern Pulp Bale Handling System has to meet thefollowing requirements: 1) Highest Efficiency/Feasibility. 2) Best Raw Material Preparation. 3) Quality Assurance , Independent from Personnel. 4) Safety of Work (Personnel). 5) Safety of Down-stream Equipment after Pulper. II. Automatic Waste Paper Bale Dewiring and Pulper Feed Systems. The erection of Waste Paper recycling lines in the Paper and Board Industry with production capacities up to and above 1,000 t/d is calling for highest standards and challenges for mechanical engineering. Paper manufacturing, based on Waste Paper, is looking nowadays for most economic and customised turnkey solutions for optimal material handling and processing in front of conventional Pulpers or Pupling Drums. FMW solutions include also approved machinary and equipment with highest efficiency for Automatic Waste Paper Bale Dewiring, wire treatment and reject handling systems. (author abst.) |
