| Accession number;99A0375086 |
| Title;Electrical Design of a Metal Grid Circularizer. |
| Author;KOTAJIMA HIROSHI(Hosei Univ., Coll. of Eng.) KAWAMURA KYOTARO(Hosei Univ., Coll. of Eng.) |
Journal Title;IEIC Technical Report (Institute of Electronics, Information and Communication Engineers)
|
Journal Code:S0532B
|
ISSN:0913-5685
|
|
VOL.98;NO.600(RCS98 197-214);PAGE.87-92(1999)
|
| Figure&Table&Reference;FIG.4, REF.12 |
| Pub. Country;Japan |
| Language;Japanese |
| Abstract;In electronic and optical systems it is necessary to convert a linearly polarized wave into a circularly polarized wave. Such converters utilized in the field of microwave engineering are generally termed "circularizers". The simplest type of circularizer is a parallel-metal-plate structure which is widely used for suppression of precipitation clutter in radar systems. The disadvantage is that this circularizer tends to be quite large physically. In this paper, a thin circularizer of practical interest is described which has been designed employing both the TE10 and the TEM modes in homogeneous dielectric filled, metal plates. (author abst.) |
